Please see below for step by step instructions on how to replace your Wattbike Nucleus saddle.
1. Use a 14mm spanner to loosen the tension nut and fully remove the saddle and saddle clamp off the slider.
2. Remove one of the 14mm nuts and slide the locking bolt from out of the saddle clamp, and remove the outer plates of the saddle clamp.
3. Roll the inner plates away from the clamp and remove the centre of the clamp from inside the saddle rails.
4. With the new saddle, reverse the process.
This Wattbike is currently only available for commercial use. For purchase enquiries, please contact:
Tel: 03 8766 0420 / 0414 316131